Zyxel P660HW Login: Default IP & Password

Log in to the Zyxel P660HW at 192.168.1.1 with admin and 1234, check the variant table for your model, and fix the login faults that keep owners out.

I have set up Zyxel Prestige P-660HW gateways for ADSL customers, and the same thing trips owners up every time. The first login asks you to change the password, the session times out after five minutes, and the ISP variants use a different address again. Your gateway is online, and the right login is printed in the Zyxel manuals.

This guide gives you the P660HW login, the variant table, and the steps that get you in.

The Zyxel P660HW logs in at 192.168.1.1 with the username admin and the password 1234. The first login prompts you to change the password — click Ignore to keep 1234, or set a new one right away.

The fastest way in: tap the button below, then sign in with the details in the box.

🔐 Zyxel Router Admin Login

IP Address: 192.168.1.1

Username: admin

Password: 1234

Login to Admin Panel →

This button opens our 192.168.1.1 login guide, which takes you to the router itself. It works only when your device is connected to that router, by WiFi or cable. If your model is a P-660HW-T3 on an ISP variant, try 10.0.0.138 instead.

How to Log in to the Zyxel P660HW

Check the model on the label of your own gateway before you type anything.

  1. Connect your computer to the P660HW with an Ethernet cable or over its Wi-Fi network.
  2. Open a browser and go to 192.168.1.1. Type the address into the address bar, not the search bar.
  3. Type admin in the username field and 1234 in the password field, then click Login.
  4. If the first-login screen asks you to change the password, set a new one or click Ignore to keep 1234.
  5. The admin panel opens, and you can change the Wi-Fi details or check the ADSL connection.
Zyxel P660HW login laptop desk work wifirouterzone.com
Connect by cable or Wi-Fi before you open the login page.

Zyxel P660HW Default Username and Password

I have seen this catch owners out: the P-660HW family has several sub-models, and one of them uses a different password. The table below lists every variant I could verify from the Zyxel manuals, so find yours and try its row first.

ModelUsernamePasswordLogin IP
P-660HW-T1 / T3admin1234192.168.1.1
P-660HW-D1admin1234192.168.1.1
P-660HW-61admin1234192.168.1.1
P-660HN-51adminpassword1192.168.1.1
P-660HW-T3 (ISP variant)admin123410.0.0.138

If your model is not in the table, start with admin and 1234 at 192.168.1.1. That is the pair the P-660 series support notes print, and it is the gateway most P660HW owners have at home. The user-level password is user, not admin, so do not mix the two up.

The 10.0.0.138 address comes from an older port-forward page for the T3 and is likely an ISP variant, while every Zyxel manual says 192.168.1.1. I try 192.168.1.1 first and keep 10.0.0.138 as the fallback, not the default.

Change Zyxel P660HW WiFi Password and Network Name

I change the Wi-Fi password first on every gateway I set up, because the factory key is printed in the manual for anyone to read. Once you are logged in, the change takes about a minute.

  1. Log in at 192.168.1.1 with admin and 1234.
  2. Open the wireless settings in the admin panel.
  3. Type your new network name (SSID) in the network name box and save it.
  4. Set the security to WPA2, then type a new Wi-Fi password.
  5. Save the settings, then reconnect your devices with the new password.

The P660HW ships with OTIST one-touch wireless security, and its setup key is 01234567. I turn OTIST off once the Wi-Fi password is set by hand, because a printed setup key is not a secret worth keeping.

The admin session times out after five minutes of no activity, so I keep the steps short and save often. If the panel logs you out mid-change, log back in and check whether the last save went through before you repeat it.

Zyxel P660HW Login Not Working?

  • Make sure your device is connected to the P660HW network, not to mobile data or a different Wi-Fi network.
  • Check that the DSL cable is plugged into the port labelled DSL, and that you are on a LAN port or the P660HW Wi-Fi.
  • Try admin and 1234 first. Admin and admin does not work on the P660HW, even though some sites print it.
  • Try the right address for your variant. Most P660HW units use 192.168.1.1, but an ISP T3 may use 10.0.0.138.
  • Check that Caps Lock is off, and type the password exactly as it is — passwords are case-sensitive.
  • Restart the gateway: unplug it, wait 30 seconds, and plug it back in.

If you still cannot log in because the password was changed and forgotten, reset the router to factory settings: press the RESET button on the rear panel and hold it for about 10 seconds until the PWR/SYS light blinks, then let go.

A reset erases every setting, and the gateway will ask you to set it up again. If the login page will not open at all, check that you are using the right gateway address with our router IP finder.

Zyxel P660HW Key Specs

The Prestige P-660HW-T series is an 802.11g wireless ADSL2+ 4-port gateway. It pairs a built-in ADSL2+ modem with a 4-port 10/100 switch, a stateful firewall, NAT and multi-NAT, and PPPoE and PPPoA for the ADSL connection. The wireless side runs 802.11g with WPA and WPA2, and OTIST one-touch setup with the key 01234567.

The admin session times out after five minutes, which is short enough to catch owners mid-change. The gateway shipped between 2005 and 2009, so it is long out of support — I treat any P660HW still in service as a legacy device and plan its replacement rather than relying on it for new security work.

The P660HW is the gateway where the first-login prompt matters most. Type admin, type 1234, and the panel opens at 192.168.1.1 — then set a new password before the five-minute session runs out. Check the sub-model on the label, and the right row in the table is obvious.

ZyXEL P-660HW problems users report, and what fixed them

WiFi dies after hours of IPTV

ZyXEL release notes for the P-660HW-T1 v2 describe a bug where WiFi stopped passing traffic after 3 to 4 hours of IPTV, needing a reboot. Update to the latest firmware for your hardware version.

Disconnects and reboots 5 or 6 times a day

A TRUE customer’s P-660HW-T1 v2 kept dropping even after a firmware update. Forum members pointed to a low downstream SNR, which means a phone line fault, not the router.

Weak WiFi from the built-in radio

An Eircom user got about 10 Mbps from the ZyXEL WiFi and 18 Mbps after adding a separate router. Turning the ZyXEL into a bridge and using a newer router fixed both speed and printer discovery.

FAQs About Zyxel P660HW Login

The Zyxel P660HW logs in at 192.168.1.1 with the username admin and the password 1234. That pair comes from Zyxel’s own P-660 series support notes. The first login prompts a password change, and I click Ignore to keep 1234 or set a new one right away.

Most P660HW units use 192.168.1.1, and that is the address every Zyxel manual prints. An older port-forward page lists 10.0.0.138 for the P-660HW-T3, which is likely an ISP variant, so I try 192.168.1.1 first and keep 10.0.0.138 as the fallback.

Admin and admin was never the P660HW default. The manuals print admin and 1234, and one site’s admin/admin claim is contradicted by Zyxel’s own documents. I type 1234, not admin, as the password.

Log in at 192.168.1.1, open the wireless settings, type a new network name and password, and save. I write the new password down before I save it, and I save quickly, because the admin session times out after five minutes.

Press the RESET button on the rear panel and hold it for about 10 seconds until the PWR/SYS light blinks, then let go. A reset restores the password 1234 and the LAN IP 192.168.1.1, and it erases the ADSL and Wi-Fi settings, so you will need to set the gateway up again.

The team behind this guide
Grace Muller

Grace Muller found this topic
Content Strategist
Focus: Topic Planning & Coverage

Lucas Meyer

Lucas Meyer wrote this guide
Content Writer · Published November 20, 2026
Focus: Router Security

Nina Petrova

Nina Petrova designed the visuals
Graphic Designer
Focus: Brand & Illustrations

Awais

Awais verified the facts
Founder & Editor-in-Chief · Last verified: November 2026
Focus: Final fact-check & publishing

Similar Posts